Post B6HOjxbO06zBfzCtN2 by gsuberland@chaos.social
 (DIR) More posts by gsuberland@chaos.social
 (DIR) Post #B6HOjxNCqpdwy0ZZGi by gsuberland@chaos.social
       0 likes, 0 repeats
       
       reading a reddit thread about adding mass to 3D prints when someone casually warns others not to use sand.why? is it because it might get into the leadscrews and cause damage?no, it's because they 3D printed a fleshlight in TPU and used sand to add extra heft to it, and then apparently proceeded to pound it so hard that the print split, leading to a far more abrasive experience than they had hoped for.
       
 (DIR) Post #B6HOjxbO06zBfzCtN2 by gsuberland@chaos.social
       1 likes, 0 repeats
       
       this would be an awful way to discover an orbital sander kink
       
 (DIR) Post #B6HOkxnEm9IyYhEES0 by thepi@urusai.social
       1 likes, 0 repeats
       
       @gsuberland Whatever OP was trying to do, that commenter's advice is almost certainly irrelevant. I hope somebody told that guy to pound sand.