Post B4SoVsFtj05yzBd02i by azonenberg@ioc.exchange
 (DIR) More posts by azonenberg@ioc.exchange
 (DIR) Post #B4SoPPn0eDJYxl2HTs by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       Do they make adapters from hose barbs and/or NPT fittings to luer lock?
       
 (DIR) Post #B4SoVsFtj05yzBd02i by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       Well ok ultimately I need CGA 580 to luer lock but the regulator has a NPT output and there's going to be tubing in the middle
       
 (DIR) Post #B4SoZqHV0TXs1OGkgy by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       Goal is a relatively high pressure, extremely focused jet of dry N2 out like a 20 ga blunt needle
       
 (DIR) Post #B4fVc7DRducX33DqMq by GetzlerChem@mstdn.science
       0 likes, 0 repeats
       
       @azonenberg how high of pressure? I do a lot of compressed gas and air free work and have a few workarounds
       
 (DIR) Post #B4fVjgnpjJOpRir1hQ by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       @GetzlerChem not sure how much will be needed to dislodge the debris from the milling area yet. I'd guesstimate 5-50 psi and will start from the low end and work up. Have to check what regulators I have lying around and what pressure ranges I can test with
       
 (DIR) Post #B4fVvXtEh3RfHK2DfE by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       @GetzlerChem trying to do chip removal from a machining operation with a 250 μm endmill and normal shop air blowguns are... A bit excessive at these scales
       
 (DIR) Post #B4fXSGhFjqUfSsb4rY by GetzlerChem@mstdn.science
       0 likes, 0 repeats
       
       @azonenberg if you think 10-15 psi will do it, I have a strategy that should work. I’ll send pix tomorrow when I can get into lab
       
 (DIR) Post #B4fXZwxgzoTUZhwvZY by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       @GetzlerChem no rush I'm on the way home from a conference and won't be able to try out any ideas for a bit anyway