Post AWmXc0o6c2cko3QoEq by socketwench@hackers.town
 (DIR) More posts by socketwench@hackers.town
 (DIR) Post #AWmK79u9RJIidmDVia by Polychrome@poly.cybre.city
       2023-06-17T09:41:28.343547Z
       
       0 likes, 0 repeats
       
       The PLA and 3D printer documentation says it needs to be at 200-210c but it leaks and strings horribly if I don't put it at 180c which seems potentially low :blobcatthonking:​#3dprinting
       
 (DIR) Post #AWmNfqjH1bnbAPMWwK by defrisselle@mastodon.sdf.org
       2023-06-17T10:20:45Z
       
       0 likes, 0 repeats
       
       @Polychrome What brand and type   That is on the low end of the temp range  Might get some clogging
       
 (DIR) Post #AWmNftGfaPhX2Z0EGu by Polychrome@poly.cybre.city
       2023-06-17T10:21:21.515586Z
       
       0 likes, 0 repeats
       
       @defrisselle Prusa Mini, using Prusament PLA.
       
 (DIR) Post #AWmSZfXuBuJyW1uvx2 by defrisselle@mastodon.sdf.org
       2023-06-17T10:23:42Z
       
       0 likes, 0 repeats
       
       @Polychrome Might not be dry or dry enough
       
 (DIR) Post #AWmXc0o6c2cko3QoEq by socketwench@hackers.town
       2023-06-17T12:07:41Z
       
       1 likes, 0 repeats
       
       @Polychrome That happens to me a lot. Usually I only take the factory temperature as a starting point and use temperature towers to dial it in per printer.  It can even vary between colors of the same material.