Post B89YoEwqXEqiorKwF6 by elly@donotsta.re
 (DIR) More posts by elly@donotsta.re
 (DIR) Post #B89YoEwqXEqiorKwF6 by elly@donotsta.re
       0 likes, 0 repeats
       
       I thought RGB headers on this board would be useless, but reading the manual JRGB1 is 12V and this got me thinking that I could use it to control LED strips behind my monitors...Until now I used a cheap remote that came with it and cut antenna traces in the controller (because it was brottkasting open WiFi and BT, expecting you to use an app) but sure enough, I can route RGB signals out and use OpenRGB to control LEDs on my desk. This also confirms that built-in RGB controller works with coreboot flashed to this board :ablobcatbongo:[CCFL flicker warning, not much I could do about it]
       
 (DIR) Post #B89YoF9bln3dSRJ88O by domi@donotsta.re
       0 likes, 0 repeats
       
       @elly THAT is such a neat hack. maybe i’ll do the same thing for my place :D