Post B6Ezno4gTmFE7DjDcG by rf@mas.to
 (DIR) More posts by rf@mas.to
 (DIR) Post #B6EvjpBvz88AbXxuOu by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       This will get better when the rack kit for the SPD3303X-E comes in but for now it's just sitting on a shelf.Now I have a DUMPTRUCK plus the STM32MP2 x Kintex-7 test board all wired up with power, jtag, annd serial console for remote firmware/gateware dev work.Free bench space, coming soon (slowly)
       
 (DIR) Post #B6ExQ6vAYahjhzqoyW by ChuckMcManis@chaos.social
       0 likes, 0 repeats
       
       @azonenberg I'm kind of digging the 'use a rack shelf' to setup the system under test.
       
 (DIR) Post #B6ExVmGaGNONO3ZNaK by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       @ChuckMcManis it's a nice high density way to connect and cable a lot of hardware that wasn't engineered with rack mounting in mind from the get-go
       
 (DIR) Post #B6ExaTQZjVI8PJTy3k by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       @ChuckMcManis note that those standoffs are screwed to the shelves through the vent slots to keep everything firmly attached
       
 (DIR) Post #B6ExbBqeZuIOAw1Poe by ChuckMcManis@chaos.social
       0 likes, 0 repeats
       
       @azonenberg Yeah, I can see that. I'm thinking with a 3D printed cable management tool to attach to the shelf it would allow one to have several active setups in one's lab without consuming all the desk space!
       
 (DIR) Post #B6EyulMOrxTFlolft2 by rf@mas.to
       0 likes, 0 repeats
       
       @azonenberg without context, DUMPTRUCK sounds like one of those things we only found out about thanks to the Snowden leak
       
 (DIR) Post #B6EzgIw5qy4tVv8IAS by azonenberg@ioc.exchange
       0 likes, 0 repeats
       
       @rf it's a flash dumper
       
 (DIR) Post #B6Ezno4gTmFE7DjDcG by rf@mas.to
       0 likes, 0 repeats
       
       @azonenberg gotcha. i can dream though