Post B53aE3xpFDElZqIyCO by Lars@shitposter.world
 (DIR) More posts by Lars@shitposter.world
 (DIR) Post #B5227Aik8KqyuEphXE by Lars@shitposter.world
       1 likes, 1 repeats
       
       Last time I made beef tallow I cooked the fat on the stove top and it took quite a while to extract all of the juice. Going to try using the slow cooker this time
       
 (DIR) Post #B52FI8BRCokDcuoJsm by Lars@shitposter.world
       0 likes, 0 repeats
       
       I don't think the slow cooker method is going to work. After a couple of hours, a little bit was extracted but it just burnt on the bottom of the bowl. I'm just going to do it on the stove again tomorrow. Last time I made tallow it was on the stove and I poured it out frequently which is probably why none of it burnt.
       
 (DIR) Post #B53aE3ntq7IV53f2jA by billiam@shitposter.world
       0 likes, 0 repeats
       
       @Lars Sounds like you're trying dry rendering. Your temperature is too high. Either set your temperature lower (225 F) or consider wet rendering.
       
 (DIR) Post #B53aE3xpFDElZqIyCO by Lars@shitposter.world
       0 likes, 0 repeats
       
       @billiam I dont have much control with the crock pot and it was already on low. I gave up on it after seeing the burnt bits. Im currently doing it on the stove top