Post B4E5xoOETTcQxH2Em8 by djsundog@fedi.reclaim.technology
 (DIR) More posts by djsundog@fedi.reclaim.technology
 (DIR) Post #B4E5xo9hLVzcECEd7Y by djsundog@fedi.reclaim.technology
       0 likes, 0 repeats
       
       hmm. wonder if any of the #3DPrinting FDM slicers have implemented an infill strategy of “organic tree supports” - just pretend internal overhangs are outside even though they’re inside. like, grow my mesh a skeleton for this orientation. that’d probably be a neat thing.
       
 (DIR) Post #B4E5xoOETTcQxH2Em8 by djsundog@fedi.reclaim.technology
       0 likes, 0 repeats
       
       plz plz plz let this nerdsnipe someone into making it happen haha
       
 (DIR) Post #B4E5xoYVrFqHT9qRnc by linear@nya.social
       0 likes, 0 repeats
       
       @djsundog@fedi.reclaim.technology i think cura has this? but it's been a while since i touched it