Post Axdkgu6QuevpmB8PvU by DJGummikuh@mastodon.social
 (DIR) More posts by DJGummikuh@mastodon.social
 (DIR) Post #Axdkgpx4LX44tyism8 by DJGummikuh@mastodon.social
       2025-08-21T22:38:52Z
       
       1 likes, 1 repeats
       
       After like half a year, my 16-color filament changer is finally finished. All 16 channels now have a buffer and are wired up, though so far I only have 10 channels loaded. My custom-built code for the tradrack on my duet printer also supports replacing run-out filaments mid print without complaint, which cuts down on waste due to "almost-empty" spools. Everything for this done by me was created in #FreeCAD 💪 #3DJGummikuh
       
 (DIR) Post #AxdkgsfoEA2bLJfdmy by FreeCAD@fosstodon.org
       2025-08-22T10:39:48Z
       
       1 likes, 0 repeats
       
       @DJGummikuh SO MANY filaments! Ace work.
       
 (DIR) Post #Axdkgu6QuevpmB8PvU by DJGummikuh@mastodon.social
       2025-08-22T10:40:48Z
       
       1 likes, 0 repeats
       
       @FreeCAD thank you a lot! I can assure you that I was at the point where I considered evaluating flight performance out of the window of the entire setup 🤣