Post AnkQm8s92mPegNNTyC by ovyerus@aus.social
 (DIR) More posts by ovyerus@aus.social
 (DIR) Post #AnkQm8s92mPegNNTyC by ovyerus@aus.social
       2024-03-11T13:38:40Z
       
       1 likes, 1 repeats
       
       First few drives installed! Should reprint the caddies in PETG eventually but that means a bunch of recalibrating I can't be bothered to do right now lol.
       
 (DIR) Post #AnkQm9zyr8H6Ay3Fp2 by feliks@chaos.social
       2024-11-05T23:32:27Z
       
       0 likes, 0 repeats
       
       @ovyerus looking good. what are the models you used and the chassis?
       
 (DIR) Post #AnkQmBWdBDzCuWKqLw by ovyerus@aus.social
       2024-03-13T00:33:31Z
       
       0 likes, 0 repeats
       
       Sweet, don't need to fuck with the RAID card to let me use the disks like god intended (with ZFS)
       
 (DIR) Post #AnkRnMvCOW3EV0xGxk by ovyerus@aus.social
       2024-11-05T23:43:52Z
       
       0 likes, 0 repeats
       
       @feliks I made the model as a remix of an existing one, just added the little handle to make pulling them out much easier, and this is an IBM x3650 M3.https://www.printables.com/model/809765-ibm-x3650-disk-caddy-screwless-with-handle
       
 (DIR) Post #AnkYiXvwiwFcsqx5sm by feliks@chaos.social
       2024-11-06T01:01:27Z
       
       0 likes, 0 repeats
       
       @ovyerus nice thx