(TXT) View Source
       
       # DANPEX CORPORATION (ADI SYSTEMS, INC.)
       
          Aquila AQ-NE/2CX (MCA)
       
          NIC Type         Ethernet                                      
          Transfer Rate    10Mbps                                        
          Data Bus         16-bit MCA                                    
          Topology         Linear bus                                    
          Wiring Type      RG-58A/U 50ohm coaxial                        
                                                                         
                           AUI Transceiver via DB-15 port                
          Boot ROM         Available                                     
       
 (IMG) IMG 1
          
       
          +------------------------------------------------------------+
          |                         CABLE TYPE                         |
          |------------------------------------------------------------|
          |              Type              |    JP2A    | JP2B - JP2I  |
          |--------------------------------+------------+--------------|
          | » |   RG-58A/U 50ohm coaxial   | Pins 1 & 2 |  Pins 2 & 3  |
          |   |                            |   Closed   |    Closed    |
          |---+----------------------------+------------+--------------|
          |   | AUI transceiver via DB-15  | Pins 1 & 2 |  Pins 1 & 2  |
          |   |            port            |   Closed   |    Closed    |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                     ONBOARD TERMINATOR                     |
          |------------------------------------------------------------|
          |             Mode             |             JP3             |
          |------------------------------+-----------------------------|
          | »         |      Enable      |      Pins 1 & 2 Closed      |
          |-----------+------------------+-----------------------------|
          |           |     Disable      |      Pins 2 & 3 Closed      |
          |------------------------------------------------------------|
          | Note:If the card is on either end of a linear bus network  |
          | segment, the onboard terminator may be used instead        |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                     DIAGNOSTIC LED(S)                      |
          |------------------------------------------------------------|
          | LED  | Color  |  Status  |            Condition            |
          |------+--------+----------+---------------------------------|
          | LED1 | Green  |   Off    |        Normal operation         |
          |------+--------+----------+---------------------------------|
          | LED2 | Yellow | Blinking |    Data is being transmitted    |
          |------+--------+----------+---------------------------------|
          | LED2 | Yellow |   Off    |  Data is not being transmitted  |
          |------+--------+----------+---------------------------------|
          | LED3 |  Red   |    On    |  Collision detected on network  |
          |------+--------+----------+---------------------------------|
          | LED3 |  Red   |   Off    |    No collisions detected on    |
          |      |        |          |             network             |
          |------+--------+----------+---------------------------------|
          | LED4 | Green  | Blinking |     Data is being received      |
          |------+--------+----------+---------------------------------|
          | LED4 | Green  |   Off    |   Data is not being received    |
          +------------------------------------------------------------+