DANPEX CORPORATION (ADI SYSTEMS, INC.)
======================================

   Aquila AQ-NE/2CX (MCA)

   NIC Type         Ethernet                                      
   Transfer Rate    10Mbps                                        
   Data Bus         16-bit MCA                                    
   Topology         Linear bus                                    
   Wiring Type      RG-58A/U 50ohm coaxial                        
                                                                  
                    AUI Transceiver via DB-15 port                
   Boot ROM         Available                                     

<gopher://bitreich.org/I/th99/n/C-D/40163-1.png>
   

   +------------------------------------------------------------+
   |                         CABLE TYPE                         |
   |------------------------------------------------------------|
   |              Type              |    JP2A    | JP2B - JP2I  |
   |--------------------------------+------------+--------------|
   |>> |   RG-58A/U 50ohm coaxial   | Pins 1 & 2 |  Pins 2 & 3  |
   |   |                            |   Closed   |    Closed    |
   |---+----------------------------+------------+--------------|
   |   | AUI transceiver via DB-15  | Pins 1 & 2 |  Pins 1 & 2  |
   |   |            port            |   Closed   |    Closed    |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                     ONBOARD TERMINATOR                     |
   |------------------------------------------------------------|
   |             Mode             |             JP3             |
   |------------------------------+-----------------------------|
   |>>         |      Enable      |      Pins 1 & 2 Closed      |
   |-----------+------------------+-----------------------------|
   |           |     Disable      |      Pins 2 & 3 Closed      |
   |------------------------------------------------------------|
   | Note:If the card is on either end of a linear bus network  |
   | segment, the onboard terminator may be used instead        |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                     DIAGNOSTIC LED(S)                      |
   |------------------------------------------------------------|
   | LED  | Color  |  Status  |            Condition            |
   |------+--------+----------+---------------------------------|
   | LED1 | Green  |   Off    |        Normal operation         |
   |------+--------+----------+---------------------------------|
   | LED2 | Yellow | Blinking |    Data is being transmitted    |
   |------+--------+----------+---------------------------------|
   | LED2 | Yellow |   Off    |  Data is not being transmitted  |
   |------+--------+----------+---------------------------------|
   | LED3 |  Red   |    On    |  Collision detected on network  |
   |------+--------+----------+---------------------------------|
   | LED3 |  Red   |   Off    |    No collisions detected on    |
   |      |        |          |             network             |
   |------+--------+----------+---------------------------------|
   | LED4 | Green  | Blinking |     Data is being received      |
   |------+--------+----------+---------------------------------|
   | LED4 | Green  |   Off    |   Data is not being received    |
   +------------------------------------------------------------+