(TXT) View Source
# LONGSHINE MICROSYSTEM, INC.
LCS-6610HX Rev. 2
+------------------------------------------------------------+
+------------------------------------------------------------+
Data bus: 16-bit, ISA
Size: Half-length, full-height card
Hard drives supported: Two MFM ST506/412 drives
Floppy drives supported: None
Max. Heads and Cyls.: 16 Heads and 1024 Cyls.
(IMG) IMG 1
+------------------------------------------------------------+
| CONNECTIONS |
|------------------------------------------------------------|
| Function | Location |
|----------------------------------------------+-------------|
| 4-pin connector-drive active LED | CN1 |
|----------------------------------------------+-------------|
| 20-pin data cable connector-drive 0 | CN2 |
|----------------------------------------------+-------------|
| 20-pin data cable connector-drive 1 | CN3 |
|----------------------------------------------+-------------|
| 34-pin control cable connector-hard drive | CN4 |
+------------------------------------------------------------+
+------------------------------------------------------------+
| USER CONFIGURABLE SETTINGS |
|------------------------------------------------------------|
| Function | Location | Setting |
|---------------------------------+-------------+------------|
| » | Hard drive port address | JP4 | open |
| | is 1F0-1F7h | | |
|-----+---------------------------+-------------+------------|
| | Hard drive port address | JP4 | closed |
| | is 170-177h | | |
|-----+---------------------------+-------------+------------|
| » | BIOS other than DTK on | JP5 | closed |
| | host | | |
|-----+---------------------------+-------------+------------|
| | DTK BIOS on host | JP5 | open |
|-----+---------------------------+-------------+------------|
| » | LCS-6610HX is not | JP7 | open |
| | grounded to host | | |
|-----+---------------------------+-------------+------------|
| | LCS-6610HX is grounded to | JP7 | closed |
| | host | | |
|------------------------------------------------------------|
| Note:Jumper JP1, JP3, and JP8 are reserved and must be |
| left "open."JP9 is reserved and must be left pins 1 & 2 |
| "closed."This controller contains no on-board software. |
+------------------------------------------------------------+