LONGSHINE MICROSYSTEM, INC. =========================== LCS-6610HX Rev. 2 +------------------------------------------------------------+ +------------------------------------------------------------+ Data bus: 16-bit, ISA Size: Half-length, full-height card Hard drives supported: Two MFM ST506/412 drives Floppy drives supported: None Max. Heads and Cyls.: 16 Heads and 1024 Cyls. +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |----------------------------------------------+-------------| | 4-pin connector-drive active LED | CN1 | |----------------------------------------------+-------------| | 20-pin data cable connector-drive 0 | CN2 | |----------------------------------------------+-------------| | 20-pin data cable connector-drive 1 | CN3 | |----------------------------------------------+-------------| | 34-pin control cable connector-hard drive | CN4 | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Location | Setting | |---------------------------------+-------------+------------| |>> | Hard drive port address | JP4 | open | | | is 1F0-1F7h | | | |-----+---------------------------+-------------+------------| | | Hard drive port address | JP4 | closed | | | is 170-177h | | | |-----+---------------------------+-------------+------------| |>> | BIOS other than DTK on | JP5 | closed | | | host | | | |-----+---------------------------+-------------+------------| | | DTK BIOS on host | JP5 | open | |-----+---------------------------+-------------+------------| |>> | LCS-6610HX is not | JP7 | open | | | grounded to host | | | |-----+---------------------------+-------------+------------| | | LCS-6610HX is grounded to | JP7 | closed | | | host | | | |------------------------------------------------------------| | Note:Jumper JP1, JP3, and JP8 are reserved and must be | | left "open."JP9 is reserved and must be left pins 1 & 2 | | "closed."This controller contains no on-board software. | +------------------------------------------------------------+