
        RGLister v1.0 Alpha
        Catalystic Creations
        written by, Justin Day

        This version is not for general release!

        RGLister is replacement for the normal Renegade file listing
        routine.  It supports 17 extra lines of description, for a
        total of 23 lines.  I wrote it when I was finally fed up with
        the normal 5 lines, and I didn't like the annoying pauses and
        flagging problems associated with description extenders.

        In addition to the increase in description size RGLister allows
        the user to use a simple light-bar interface.


        There are 5 basic commands to RGLister:  Next, Flag, Info, Help
        and Quit.  You can use these commands in two ways:

                1)  Use the arrow keys to highlight the command
                    you wish to use and press ENTER.

                2)  Press the first letter of the command.



        Here is a quick review of the commands:


           [N]ext  -  Show the next page of files.
           
           [F]lag  -  Flag file(s)

                      Flagging files is very simple.. Just move the
                      light-bar to the file you wish to flag.  You
                      may use the arrow keys or A and Z if you're
                      terminal doesn't support the arrows.  Once you
                      have the file you wish to flag highlighted
                      hit the space bar.  

                      Flagged files are shown in red.  They may be
                      un-flagged by simply highlighting the file(s)
                      and pressing the space-bar.

                      Once you've completed your flagging press ENTER.

                      NOTE:  The files are not actually put into the
                      Renegade batch queue until you exit RGLister.
                      RGLister does not check to see if you have enough
                      credits or ratio to download a file, so you will
                      not know until exiting RGLister.
           
           [I]nfo  -  Show Extended Information on a file.

                      To see information on a file simply highlight the
                      file you want more information on, using the arrows 
                      or A and Z, and press ENTER.
                      
           [H]elp  -  You're looking at it.

           [Q]uit  -  Quits RGLister and puts files in the batch queue
                      if any.



