Subj : Re: DoorMUD
To   : IB Joe
From : Richard Cini
Date : Wed Sep 30 2020 05:24 pm

On Saturday, September 12, 2020 at 4:24:12 PM UTC-4, IB Joe wrote:
> g0> Their own documentation doesn't work, so it can be confusing. 
> g0> 
> g0> If you have doormud installed in c:\doormud then you would do: 
> g0> 
> g0> Command: D3 (Execute Door32 Program) 
> g0> Data: c:\doormud\dmud32d -n %N -d %Pdoor32.sys 
> g0> 
> g0> This assumes you're using the 32-bit version. 
> g0> 
> 
> Yup, 32Bit and I was able to take this information and make the other doors 
> to work...
> Thanx 
> 
> IB Joe 
> AKA Joe Schweier 
> SysOp of Joe's BBS 
> -=JoesBBS.com=-

I'm actually having some challenges with this, too. I changed the external command from what was in the dmud manual to the above, and I get further along, but now I get an error "Unable to read door information file". My setup is going to be used as a 
dial-up demo for a computer museum, so it's older -- 1.07.3 running on Windows 98SE with a Digi AccelPort board. The board itself works fine, and I can get Pimpwars running, but dmud is a challenge. 

Thanks!

Rich
IMSAI Long Island

--- SoupGate-Win32 v1.05
 * Origin: Agency HUB, Dunedin - New Zealand | Fido<>Usenet Gateway (3:770/3)

.