Subj : SEXPOTS - Pulling my hair out... :)
To   : Digital Man
From : cafarmer
Date : Tue Jun 11 2024 05:46 am

I am only working with the 1200 right now to avoid confusion. The hope was that
if I figured out the 1200, the Optima 28.8 would be easier as it is newer.

The only manual I have right now is the HSM 300. I was assuming if it was in
that manual, the 1200 would support it as well. So, in the HSM 300 manual,
there is some info on the Carrier Signal, Cn. But they don't ever show an
example of how it it used. So when I tried ATC1, the HSM 1200 responded with
"OK". But then I tried to read that back by typing ATC?, it responded "000". So
I wasn't sure what was going on there. Then you stressed ATCn and AT&Cn were
different. So, I tried AT&C1 and it responded "ERROR".

I tried setting IgnoreDCD = FALSE a while ago thinking it might affect the
behavior, but it didn't. If I recall, it still picked up a "Carrier Detected"
and made the connection to the TCP endpoint without ever receiving an actual
call. It's not really fair to you to present recollection vs. a controlled test
with output, so maybe later today, I will set the IgnoreDCD and provide the
..ini settings along with the output. BTW, Debug didn't reveal anything I could
use to figure it out either.

As always, thank you very much for your help.

-Chris

.