Subj : Building
To   : All
From : Paul Hayton
Date : Sat Sep 24 2022 09:37 pm

Hi there

It's been some time since I built Husky software and when I did it was using a process that has now changed.

I've been following the new steps and am up to looking at huskymak.cfg and the changes I need to make to it.

I'm comparing my old huskymak.cfg from the old building process with the new one.

My question is that in my old .cfg I had a switch DYNLIBS=1 whereas the default setting for the new huskymak.cfg is DYNLIBS=0

I'm wondering if I should set this to 1 or leave as default?

My system is a Debian Linux one and I am not a very experienced Linux user..

Kerr Avon [Blake's 7] 'I'm not expendable, I'm not stupid and I'm not going'
avon[at]bbs.nz | bbs.nz | fsxnet.nz 

--- Mystic BBS v1.12 A47 2021/12/24 (Linux/64)
 * Origin: Agency BBS | Dunedin, New Zealand | agency.bbs.nz (3:770/100)

.