Subj : Multiple NodeDiff files To : Gerald Miller From : Gord Hannah Date : Sun Jan 04 2004 08:35 am Replying to a message from Gerald Miller 1:342/512 to Paul Quinn, About Multiple NodeDiff files, On Sat Jan 03 2004 Just a question: Have you looked at Qnode? From Qnode Doc: 1.5 - MULTIPLE NETWORKS QNode also supports the compilation of many different input nodelists into one big output file. This is used for the inclusion of other networks (like SIGnet for example.) The configuration file command which enables this is the 'NODELIST' command, which instructs QNode on which nodelists that it is supposed to compile. To compile a joint Fidonet, Signet system you would use the two commands: 'NODELIST NODELIST' and 'NODELIST SIGNODES'. WARNING: If you use a 'NODELIST' command in your configuration file, then the default fidonet nodelist will NOT be included. You must explicitly include the 'NODELIST NODELIST' statement if you still wish to include the fidonet nodelist. There is a special type of input nodelist called a 'modification' nodelist. It can be used to insert points, or even zones, regions, nets, hubs, or basically anything. It is most often used to insert points though. The basic form of the modification nodelist is: ---cut here--- Zone,1,-> Region,17,-> Host,140,-> ,26,-> Point,1,The_North_Village,Saskatoon_Sk,James_West,1-306-384-0836,9600 ---cut here--- All lines which are used to advance the current node position must be terminated with the ",->" sequence, and may not have any other characters after that sequence. WARNING: 'modification' nodelists will probably severely confuse a version 6 nodelist. They are only for the use of version 7 nodelists. Hope this helps. Keep us posted. We are a fine board trying to make it better. http://www.pris.bc.ca/ghannah ghannah@pris.bc.ca Cheers! Gord -=Team OS/2=- --- timEd/2 1.10.y2k+ * Origin: Marsh BBS (c), Dawson Creek, BC Canada (1:17/23.1) .