Subj : Binkley problems with 1:300/3
To   : Janis Kracht
From : Benny Pedersen
Date : Tue Feb 19 2013 06:37 pm

Hello Janis!

13 Apr 2012 13:59, Janis Kracht wrote to All:

 JK> Has anyone run into something like this?

 JK>  | 13:53 Trying to handshake                   | CONNECT 
 JK> 16800/ARQ/V34/LAPM/V4

that was the days here :)

 JK> Passwords are correct.. 1:300/3 can dial here and deliver no problem.  
 JK> Password protected sessions constantly fail on session-level though if 
 JK> I dial him.

try connect on 2400 baud ?

 JK> Bob writes to me:

 >>>> I see you're getting a connect, but no session.  As I noted, in dumb
 >>>> terminal
 >>>>> there's stuff from the modem - I did see 'Prism BBS' there. But the
 >>>> log/activity > window of Binkley shows nothing.  When I dial out,
 >>>> Binkley's log/activity  window shows all the steps of the connect
 >>>> and traffic passing.  But not incoming.
 >> I can connect with you, and all that
 >>shows up in the activity/log window, but nobody can connect with me - and 
 >>when they try nothing shows up in the activity/log window..
 >>>> The flags in binkley.evt are B M R - BBS, Mail >>> Receive.

is the modem setup with 7 wire ?, or just 3 ?

is hardware dte ok ?

i had lots of fun with dte on 930260 with my zyxel ta 128, and isdn :)

with the old amiga 2000 and cpu just as slow as 7.14 mhz :)


 Regards Benny

.... there can only be one way of life, and it works :)

--- Msged/LNX 6.2.0 (Linux/3.5.7-gentoo (i686))
 * Origin: duggi.junc.org where qico is waiting (2:230/0)

.