Subj : Re: binkleyterm
To   : Richard Webb
From : Harvey Simpson
Date : Tue Jan 03 2012 02:46 pm

 > Hi Harvey,
 > 
 > On Sat 2011-Dec-31 10:02, Harvey Simpson (1:103/705) wrote to Mark Lewis:
 > 
 > HS>   Can you tell me how to setup Binkleyterm so that when I call my NC it
 > HS> will call as a local number. I am using Qnode as the nodelist compiler.
 > HS> I have gone into the cfg and put the number in there so
 > HS> that it calls local but it says you can do it the other way. When I
 > HS> do it that way it will call a number starting with 011 then the area
 > HS> code and then the number. thanks, Harvey --- SBBSecho 2.12-Win32
 > <hmmm>  I assume you're compiling a v7 nodelist, I believe
 > qnode did that.
 > 
 > I can tell you how to do it in the tbbs nodelist compiler,
 > which is xlaxnode without the cripple, but either way, have
 > a look at the docs for "dial translation" or similar
 > terminology.
 > 
 > In xlaxnode or tbbsnc it would like like this.
 > Okay that would be good. Do you know how to set it up with Synchronet?

 > dial
 > 1-901-
 > end
 > 
 > Which would tell it not to dial the 901 when dialing any
 > number in the 901 area code.
 > 
 > IT's all in how your nodelist compiler does dial
 > translation.
 > 
 > I believe it can also be done in binkley.cfg.  Like at the
 > cfg guide, or the configuration guide in your binkleyterm
 > reference manual.
 > 
 > 
 > If I get time later this weekend I'll go trolling through
 > the binkley docs and see if I can find it, but I think
 > you're right, I think you can do it in the binkley.cfg file
 > as well.
 > 
 > 
 > HS>  - Origin: Vertrauen - vert.synchro.net (1:103/705)
 > 
 > Regards,
 >            Richard
 > ---
 >  * Origin:  (1:116/901)

.