Subj : binkleyterm
To   : Harvey Simpson
From : Richard Webb
Date : Sat Dec 31 2011 09:45 pm

Hi Harvey,

On Sat 2011-Dec-31 10:02, Harvey Simpson (1:103/705) wrote to Mark Lewis:

HS>   Can you tell me how to setup Binkleyterm so that when I call my NC
HS> it will call as a local number. I am using Qnode as the nodelist
HS> compiler. I have gone into the cfg and put the number in there so
HS> that it calls local but it says you can do it the other way. When I
HS> do it that way it will call a number starting with 011 then the area
HS> code and then the number. thanks, Harvey --- SBBSecho 2.12-Win32
<hmmm>  I assume you're compiling a v7 nodelist, I believe
qnode did that.

I can tell you how to do it in the tbbs nodelist compiler,
which is xlaxnode without the cripple, but either way, have
a look at the docs for "dial translation" or similar
terminology.

In xlaxnode or tbbsnc it would like like this.

dial
1-901-
end

Which would tell it not to dial the 901 when dialing any
number in the 901 area code.

IT's all in how your nodelist compiler does dial
translation.

I believe it can also be done in binkley.cfg.  Like at the
cfg guide, or the configuration guide in your binkleyterm
reference manual.


If I get time later this weekend I'll go trolling through
the binkley docs and see if I can find it, but I think
you're right, I think you can do it in the binkley.cfg file
as well.


HS>  - Origin: Vertrauen - vert.synchro.net (1:103/705)

Regards,
           Richard
---
 * Origin:  (1:116/901)

.