Installing Clip & Go
--------------------
The Clip & Go disk contains software components for both a
Windows PC and an OmniGo 100.

The Windows component installs directly to your PC hard drive.

There are two ways to install the OmniGo 100 component:

        1. Via cable. For this method, you will need an
           OmniGo Serial Cable (Hewlett-Packard part number
           F1015A or compatible) connected from your PC to
           your OmniGo.

        2. Directly to a PCMCIA card. This method requires
           a PC with a built-in PCMCIA card drive.

        Both methods require a PC running Microsoft Windows
        (version 3.1 or later) or Windows 95.

To install both components, launch the Windows application
SETUP.EXE from the Clip & Go disk, then follow the
instructions on the screen.

For more information, consult your Clip & Go User Guide.
