ETCH-3D  written by DAve Stewart for CLUB 100

  This is a REAL 3-D Plotter, using only 2k.  What more could you ask
for in life!?
  It'll make really GOOD 3-D drawing.  It's simple too.

  The TWO STEP process is as follows:

        step 1:  move the cursor to where you want the first point, ie
the 1st corner of a diamond.  Press SPACE once it's in it's final
location.  The Program will make the spot with a + and move the blinking
pixel up one and left one.  Move to the 2nd corner of the diamond, and
do the same, the 3rd and 4th the same way.  When ALL your POINTS are
marked (4 for a diamond) press RETURN.

        step 2:  The Program will 'connect the dots' you made.  Now just
hold down the space bar until the width is as YOU want it.  Press RETURN
when you've reached you desired width.

        The computer will now finish the 3-D drawing.  It's SIMPLE, and
it makes good 3-D drawings.

  NOTE: The blinking pixel is hard to see, it starts off 31 right and 31
down.  When plotting points, you can use all the height and 5/6ths of
the width of the screen.  The last 6th is used to make the thing 3-D.

  When done, press ENTER to draw another.  Suggestions, leave me a msg
on line.
  DAve Stewart