IKON ANNOUNCES TWO NEW PRODUCTS FOR MICROCHANNEL

IKON Corporation, of Seattle, WA, is pleased to announce two new high
performance interface products for MicroChannel machines.

The Model 10113 (which replaces the earlier Model 10107) is a DMA slave
interface which allows connection of any Versatec or Centronics compatible
plotter or printer.

The Model 10114 (which replaces the earlier Model 10109) is a bus slave
interface which provides connectivity to Network Systems Corporation's
high-speed networks such as HYPERchannel and HYPERbus.

Both boards use FIFO buffers to allow maintaining maximum external device
transfer rates while providing high bus efficiency. Bus-to-FIFO transfer
rates of up to 20M bytes/second may be sustained.

The Model 10113 can drive Centronics or Versatec (either TTL or
Differential) plotter/printers at up to 2M bytes/second. The Centronics
port is fully compatible with Tektronix color copiers, supporting
compressed timing and Tektronix perferred cable terminations as well as
other special terminations. Selection of Centronics/Versatec (and
TTL/Differential) is via an internal jumper cable.

DMA slave arbitration level (for the 10113) and interrupt levels (for both
boards) are selected by the POS utility at system configuration time. No
user-configurable jumpers or DIP switches are required for hardware
set-up. The interrupt level for either board may be set to 10, 11, 12 or
15. The boards may be installed in either 16 or 32 bit slots.

AIX software drivers are available for the 10113. Hardware/Software Manual
is provided. The boards are available from shelf stock and carry a full
one year warranty. Units are available for evaluation.

IKON Corp
2617 Western Ave
Seattle, WA 98121
206-728-6465,   FAX: 206-728-1633

 ============================================================
 From the  'New Product Information'  Electronic News Service
 on AOL (Keyword = New Products) & Delphi (GO BUSINESS PROD)
 ============================================================
 This information was processed from data provided by the
 above mentioned company. For additional details, contact 
 the company at the address or telephone number indicated.
 OmniPage Pro is now used for converting all printed input! 
 ============================================================
 All submissions for this service should be addressed to:
 BAKER ENTERPRISES,  20 Ferro Dr,  Sewell, NJ  08080  U.S.A.
 Email: RBakerPC (AOL/Delphi), rbakerpc@delphi.com (Internet)
 ============================================================
