Persistent Modes
reddit / irc

----------------------------------------------------------------------
voaii · 2023-04-18 23:31

When i do /SAMODE #mychannel +qo mynick and then /msg chanserv aop
#mychannel ADD mynick 4 it works to give me the privileges and prefix
that I want, but it isn't persistent. WHen I disconnect and reconnect
these modes arent automatically set upon me.

----------------------------------------------------------------------
ProgVal · 2023-04-19 05:51

`/msg chanserv aop #mychannel ADD mynick 4` is this Anope? The
documentation says:

    ***** ChanServ Help *****
    Help for xOP:

    The xOP commands allow you to maintain channel
    access lists. Channel access lists can contain
    registered accounts or hostmasks (nick!user@host).

    The exact meanings of the access levels may differ
    per network, use /msg ChanServ TEMPLATE to check. As
    a hint, VOP stands for VOice People, HOP stands for
    HalfOP, AOP stands for AutoOP, SOP stands for
    SuperOP.

    Not all channel access entries can be edited
    with these commands, see the FLAGS and FORCEXOP
    help entries for details. Note that use of
    FORCEXOP can destroy a lot of information.
    The TEMPLATE system can provide most of the
    ease of use of these commands without the
    restrictions.

    The privileges required to execute these commands are
    the same as those required for the corresponding
    FLAGS commands.

    Syntax: VOP|HOP|AOP|SOP  ADD|DEL|LIST

    Examples:
        /msg ChanServ VOP #foo ADD bar
        /msg ChanServ VOP #foo ADD foo!*@bar.com
        /msg ChanServ AOP #foo DEL bar
        /msg ChanServ SOP #foo LIST
    ***** End of Help *****


so I don't see what the `4` at the end means. Are you sure the command
is accepted? What does chanserv tell you when doing `/msg chanserv aop
#yourchannel LIST`?

(Also, `AOP` is only to make you op (`+o`), not owner (`+q`))

If that's not it, make sure you are identified before joining the
channel, maybe?

or maybe ` /msg chanserv FLAGS #yourchannel yournick +oOq` instead?
(This should give you auto-op, but probably not auto-owner; I don't
see how to do that)

----------------------------------------------------------------------
voaii · 2023-04-20 01:34

After 2 days of troubleshooting literally turning it off and back on
again did the trick. I had to restart Anope so it can recognize the
new <customprefix