ZFS failure while installing 12.3 release reddit / freebsd ---------------------------------------------------------------------- vogelke · 2022-05-01 01:56 Greetings, I just tried installing 12.3-RELEASE on a box running Oracle Linux-7.9, and I got all the way through the install with no problems. I have 5 drives; 2 are identical WD 1-TB, 2 are identical WD 3-TB, and one Crucial SSD. The system found all the drives (including the SSD, to my surprise -- it was connected via USB cable). I set up a basic mirror on the two WD 1-TB drives, figuring I'd do the rest of the disk setup later -- I want a mirrored root filesystem but other things can go on the SSD. I got into my setup menu (Intel) and asked to boot from the DVD without changing the default boot order. The install went fine, but when rebooting from the drive, I saw a ZFS failure: Solaris: zroot/ROOT/default: can't open objset 108, error 6. It tried again after three seconds, no joy. I can't reboot into single-user, and trying rescue from the DVD only shows me the DVD itself. I can do ls and lsdev, and I see drives like ada0p4 and ada1p4 listed as ZFS, but I'm not sure what to do next. Some suggestions I've found: zpool status zfs list Add the following to loader.conf: vfs.zfs.debug="1" boot_pause="YES" geom_label_load="YES" geom_part_gpt_load="YES" Tell the system more specifically what to load in /boot/loader.conf: vfs.root.mountfrom="zfs:zroot" I have another system running FreeBSD-11.4 (no problems) and /boot/loader.conf contains: kern.geom.label.disk_ident.enable="0" kern.geom.label.gptid.enable="0" zfs_load="YES" accf_data_load="YES" The last suggestions were zpool import -fR /mnt zroot zpool get bootfs zroot If that didn't give me anything, try zpool set zroot bootfs zroot I did the install under UEFI, and now I can't seem to get to my setup page at all -- pressing F2 or F10 during boot doesn't work like it used to. I'm very surprised; FreeBSD installations have always gone very smoothly in the past. Any suggestions welcome. ---------------------------------------------------------------------- grahamperrin · 2022-05-01 12:04 Did you choose to encrypt the installation? If so, some commands that may be of interest: > UEFI [efibootmgr\(8\)](https://www.freebsd.org/cgi/man.cgi?query=efibootmgr &sektion=8&manpath=FreeBSD)