Newbie concerned about partitioning drive for VM reddit / freebsd ---------------------------------------------------------------------- CerBerUs-9 · 2020-09-09 18:16 I'm spinning up a freebsd12.1 VM in VMware on win10 to read some old drives with a zfs file system. There's a ton of warnings all over the documentation about making sure it's the only file system on a drive. My drive bays are used up and my external reader needs to be used for the drives I need to read. Will the 40GB I allot in VMware be the "drive" that needs to be left for zfs or is my whole 4TB drive it's running inside going to get messed up when I try to run this? I have searched around for an answer but I've not found any direct answers or questions that actually address this. ---------------------------------------------------------------------- dddddavidddd · 2020-09-09 19:32 You can also choose to partition as UFS in the FreeBSD installer. In any case, using ZFS as the root filesystem for your VM is unlikely to cause problems, certainly not with your actual filesystems on the host. ---------------------------------------------------------------------- [deleted] · 2020-09-09 19:34 If you allocate 40gb to your vm , 40 gb will be allocated in your filesystem for that VM. If you're doing data recovery on the drive you're using you more than likely will overwrite the 'unindexed' filesystem which youre writing your vm to. If your vm is stored on another drive you should be able to get setup without touching your other drives. For drive recovery i would suggest your host being linux based / using a bootable usb to take an image of said drive in order to preserve working on a recovery drive. Hope this helps :) ---------------------------------------------------------------------- CerBerUs-9 · 2020-09-09 21:48 Unfortunately I only have two win10 computers around. My linux is all done on VM. The data I'm trying to collect is on an external drive but the VM will be on an otherwise NTFS drive. Just to make sure I understand, making that 40GB on the VM zfs on the ntfs drive will be okay? ---------------------------------------------------------------------- FUZxxl · 2020-09-10 07:53 You can use ZFS in a partition with other file systems on the disk, too. The performance is just slightly worse than using a dedicated disk for ZFS. ---------------------------------------------------------------------- truupe · 2020-09-11 15:57 You're trying to access old physical drives with zfs on them? ---------------------------------------------------------------------- CerBerUs-9 · 2020-09-11 17:25 Correct. Do you have a better idea of getting the files? ---------------------------------------------------------------------- truupe · 2020-09-11 18:17 In situations like these, I usually find a second desktop computer, install a compatible OS on a completely separate "expendable" drive. Then just use that installation to access the drive with the critical data/files. Now, if I don't have a 2nd computer, I pull ALL the drives out of the desktop and set them aside. Then, essentially do the above.