Hello with BBS Telnet Server & null modem cable reddit / bbs ---------------------------------------------------------------------- dcpanthersfan · 2019-02-15 00:43 For the most part my system works except I get these RS232:Error framing baud errors popping up often that wrecks havok with the BBS Telnet Server software. Can anyone recommend settings or changes to minimize this? Or should I be using tcpser instead? ---------------------------------------------------------------------- f15sim · 2019-02-15 02:20 What baud rate are you running at? What kind of null modem cable are you using? If memory serves, BBS Telnet Server has a pinout for a recommended one in the docs. ---------------------------------------------------------------------- dcpanthersfan · 2019-02-15 02:43 2400 baud and standard null modem cable. I have it set to null modem as well in the configuration. ---------------------------------------------------------------------- f15sim · 2019-02-15 03:33 You might want to check to make sure that both are set to 8 bits, no parity and one stop bit. ---------------------------------------------------------------------- dcpanthersfan · 2019-02-15 04:29 Both are: 2400, 8, N, 1. This is a Windows XP box. I read at lemon64 it could be needing a driver upgrade. ---------------------------------------------------------------------- f15sim · 2019-02-15 19:32 I doubt the problem is on the XP end. Have you tried it at 1200 baud? Framing errors are speed related. ---------------------------------------------------------------------- dcpanthersfan · 2019-02-15 21:24 I haven't tried at anything below 2400. I'll try it at 1200 and see how it works. How about Hardware Flow Control: on or off? (OR Xon/Xoff if it matters)?