would openbsd installer remove my untouched partitions? reddit / BSD ---------------------------------------------------------------------- zielonykid1234 · 2021-10-13 19:18 Im going to do a triple boot, but kinda don't know would openbsd installer clear all of my exiting partitions? I would to install it on free space. ---------------------------------------------------------------------- gumnos · 2021-10-13 21:16 You have two aspects to consider—the partitioning and the boot loader. What DOS/Windows/Linux calls "partitions", the BSDs tend to refer to as "slices", so you should be able to have [a blank "slice" and turn it into an OpenBSD slice, dividing it up into BSD-partitions for install](https://www.openbsd.org/faq/faq14.html#intro). Once you've installed to that slice, you also need a boot-loader that can boot to each of the main MBR/GPT parititions/slices. Grub should be able to do that, and with chain-loading to whatever loader is specified in your MBR/GPT partition. So with those two bits in mind, you might try a resource like https://srobb.net/openbsdmultiboot.html that details multi-boot with OpenBSD. ---------------------------------------------------------------------- zielonykid1234 · 2021-10-13 22:12 i don't care about that bsd is stupid and it names partitions "slices", i just want to know that would openbsd installer remove my partitions(SLICES) if i don't touch them in the partitioning(slicing? xd) or not? ---------------------------------------------------------------------- gumnos · 2021-10-13 23:14 If you only point the installer at the *partition* (BSD slice), you should be good. So you want to make sure it's pointed at something like `/dev/wd0f` (the partition/BSD slice) instead of `/dev/wd0` (the whole drive). The article to which I linked has a pretty good description of how to go about it fairly safely. But as with everything, back up important data first. ;-) ---------------------------------------------------------------------- zielonykid1234 · 2021-10-13 23:23 ok so create a partition using the system shell and next pick it up in the installer as a disk? ---------------------------------------------------------------------- gumnos · 2021-10-13 23:49 I assume the MBR or GPT partition already exists. So you just want to use `fdisk(8)` to set the partition(slice) type to OpenBSD (0xA6). It has been a while, but with that in place, the OpenBSD installer *should* identify the partition/slice as an available target and offer it to you as a candidate during the "where do you want to install" step.