NetBSD on the last G4 Mac mini (and making the kernel power failure proof) reddit / BSD ---------------------------------------------------------------------- Kernigh ยท 2019-07-01 04:30 FreeBSD and OpenBSD might run on the G4, but NetBSD is the only BSD for Mac models before the iMac. It's too bad that [the install notes for NetBSD 8.1 macppc](https://cdn.netbsd.org/pub/NetBSD/NetBSD- 8.1/macppc/INSTALL.html) are obsolete. The notes don't say to "Use existing partition sizes", but everyone seems to go that way. The article from TenFourFox says, >...when asked, indicate you will "Use existing partition sizes." This is for G4s and other models with Open Firmware 3. If you obey the install notes, you never get asked to "Use existing partition sizes". That option only appears if you do a regular install with "Install NetBSD to hard disk". The install notes avoid the regular install and give more difficult procedure where you would run `newfs` from the shell, write your own fstab, and so on. TenFourFox also says, >For some reason the mini goes berserk when trying to boot from a kernel on a NetBSD native partition, but works fine from an HFS+ one. If the kernel is on the NetBSD partition, one can rebuild or upgrade the kernel without copying it to a non-native partition. [My NetBSD 8.0 macppc in qemu](https://www.reddit.com/r/BSD/comments/a0re4e/tip_t o_install_netbsdmacppc_in_qemusystemppc/) loads the kernel from the NetBSD partition, but qemu isn't a real Mac, and I have other trouble with qemu. My old PowerBook G4 dual-boots Mac OS X 10.4 and OpenBSD macppc. OpenBSD loads the kernel from the OpenBSD partition if the partition exists.