[SOLVED] How do I use YCbCr Color space? lazarus / 62-General ---------------------------------------------------------------------- lulZghost · 2019-01-08 19:04 For a school project I have to make an converter that extracts Y, Cb and Cr channels from a picture. I found the calculations on the internet but the result doesn't look like any example. So I think I didn't use the calculated value right. I don't really find anything for YCbCr in Pascal ... because I don't really know what to do I rounded them which brought the result you can see on the attached image. y:= R *  0.29900 + G *  0.58700 + B *  0.11400; cb:= R * -0.16874 + G * -0.33126 + B *  0.50000 + 128; cr:= R *  0.50000 + G * -0.41869 + B * -0.08131 + 128; // Edit: I figured it out. I did an rough mistake while drawing the new canvases. New and correct result : https://i.gyazo.com/35034be3de10217561b98ddb4b4f243c.png. ---------------------------------------------------------------------- lucamar · 2019-01-08 19:18 You have probably seen this already but just in case: Wikipedia: YCbCr. It includes the (correct) formulae to convert from RGB. ETA: Charles Poynton's Color FAQ is a must-read-and-keep-close if you intend to do much work about color. ---------------------------------------------------------------------- jamie · 2019-01-08 22:47 G = 59% R = 30% B = 11%  Summed = Y; (Chroma)  As for the B and R channel color channels the two of them are at 50% for a gray scale.  By calculating the percentage of B and R difference of G  you get the 50%+/- depending on which direction it is with the R channel. So if R and B were both at 0 then Green would be the dominate color. going the other way, that is B and R in the + range would reduce the G gain etc Its hard to think about but I've done some slow scan software where I had to support these older style of color formats.