Cluttered line chart Y-axis lazarus / 55-TAChart ---------------------------------------------------------------------- JD · 2020-04-18 11:38 Hi there everyone, Sometimes with my application, I get a cluttered Y-axis where the values are too close to each other and are therefore unreadable (see screenshot). What do I have to do (apart from making the chart larger) to obtain a better, more readable Y-axis even if it means reducing the data points on the axis? Cheers, JD ---------------------------------------------------------------------- wp · 2020-04-18 16:46 You seem to label the y axis with the y values of the series. It this intended? Normally labels are automatically created from the data so that the ticks are equally spaced and the labels have "nice" values.  You probably assigned the chart source which provides the data points for the series also to the Marks.Source of the Chart.LeftAxis. Remove it from here and you will have nice labels. ---------------------------------------------------------------------- JD · 2020-04-22 10:41 Quote from: wp on April 18, 2020, 06:46:41 pmYou seem to label the y axis with the y values of the series. It this intended? Normally labels are automatically created from the data so that the ticks are equally spaced and the labels have "nice" values.  You probably assigned the chart source which provides the data points for the series also to the Marks.Source of the Chart.LeftAxis. Remove it from here and you will have nice labels. Thanks a lot. Once I cleared the value in LeftAxis->Marks->Source, it worked. I do have a question, is it possible to hover above a data point with a mouse and see the corresponding XY value or just the Y value? Cheers, JD ---------------------------------------------------------------------- wp · 2020-04-22 11:21 Quote from: JD on April 22, 2020, 12:41:26 pmI do have a question, is it possible to hover above a data point with a mouse and see the corresponding XY value or just the Y value? Use a TDatapointHintTool. Follow the tutorial https://wiki.lazarus.fre epascal.org/TAChart_Tutorial:_Chart_Tools#Using_a_TDataPointClickTool, but use a TDataPointHintTool instead of a TDataPointClicktool. When you want to see the popup hint only by moving the mouse you can leave the Shift property empty. ---------------------------------------------------------------------- wp · 2020-04-22 13:15 Here's a small demo...