Error dbf post ( resolu ) lazarus / 31-LCL ---------------------------------------------------------------------- Fabius · 2021-06-14 07:11 Good morning all It compiles, but at runtime, I have an error, the dataset is not in add or edit mode While I have placed the APPEND command? or do I make a mistake? Thank you for your reply procedure TForm3.Button4Click(Sender: TObject); begin   //////////////////ajouter en fin de table         if DBEdit1.text <>'' then     begin     DBEdit1.Color := clGreen;     lignesDeSaisie.Last;     Try     lignesDeSaisie.Append;     lignesDeSaisie.FieldByName('compte').AsString := Form1.Xcomptes.FieldByName('compte').AsString;     lignesDeSaisie.FieldByName('label').AsString := Form1.Xcomptes.FieldByName('label').AsString;     lignesDeSaisie.Post;     finally     end;    DBEdit3.SetFocus;     end else begin           DBEdit1.Color := clRed ;           messagedlg('Compte NON Trouvé Ou Vide .',mtinformation,[mbok],0);           StatusBar1.SimpleText:= 'Ce compte n existe pas ';     end; end; ---------------------------------------------------------------------- wp · 2021-06-14 07:45 Your code suggests that you enter the text first, then call Dataset.Append, transfer the edit text and finally post. This is possible with normal TEdit controls, but not with TDBEdit. Since the DBEdit reflects the state of the dataset you cannot enter anything before the dataset has not been switched to edit mode. Therefore, you first must call Dataset.Append, type the text and then Post. See a working example with TDBEdit in the attachment. ---------------------------------------------------------------------- Fabius · 2021-06-14 07:58 Tank You It the DBEdit3.SetFocus;  the probleme