i18n and target file name (-o)
lazarus / 31-LCL

----------------------------------------------------------------------
kupferstecher · 2018-08-26 08:09

Hello,

my programm uses the Lazarus i18n. Recently I changed the target file
name for the executable (in the project options). This as well changes
the po-files name for i18n. This behaviour is not ideal for me,
because I give different names for different targets, e.g.
 MyProgram_Win32
 MyProgram_Linux32
 MyProgram_Armv6Linux

Is there a switch to change that behaviour, i.e. that the po-file name
is chosen according the project's name?

Regards

--
Lazarus 1.8.0
Win7

----------------------------------------------------------------------
wp · 2018-08-26 11:25

You should post this question on the Lazarus mailing list because
Maxim Ganetsky who takes care of translation support only rarely reads
the forum.

----------------------------------------------------------------------
kupferstecher · 2018-08-26 15:02

Hello wp,

thanks for your reply. I didn't use the mailinglist yet, though. I'll
have a look.
Regards~

----------------------------------------------------------------------
wp · 2018-08-26 16:14

Just register at this site https://lists.lazarus-
ide.org/listinfo/lazarus and write an ordinary e-mail to the address
given there.