Tab Order in IDE lazarus / 31-LCL ---------------------------------------------------------------------- busicomp · 2014-10-26 21:55 Sorry if this has been covered, but I can't find it anywhere. The component index order(creation order) seems to be used when in the IDE, rather than the Tab Order from the components themselves. Is there a reason for this, or is it just a small annoyance? ---------------------------------------------------------------------- taazz · 2014-10-26 22:15 depends I guess, on windows tab order is a soft link to creation order it was always that way, On other operating systems this might be different. ---------------------------------------------------------------------- busicomp · 2014-10-27 00:10 I'm aware of the default order ... But when I change the order it is not reflected while in the IDE. The creation order is still used and reported. When running the executable, it uses the tab order as defined in the components, but not while in the IDE. In Delphi I generally did a quick check when I've "finished" a form, by clicking on the "1st" component and then tabbing through to check it is in a reasonable order. It's no biggie, but I just wondered if there's a reason for it. ---------------------------------------------------------------------- Martin_fr · 2014-10-27 00:19 You mean tab order of components in the designer form? It is probably because no one ever thought of it. ---------------------------------------------------------------------- busicomp · 2014-10-27 01:30 OK ... that's fine. Thanks. ---------------------------------------------------------------------- Martin_fr · 2014-10-27 01:31 You can always open an issue/request in mantis.