[SOLVED] New "category" of controls in the IDE?
lazarus / 31-LCL

----------------------------------------------------------------------
pusuni · 2014-10-03 10:19

Hi! Sorry if this message it is not in the correct place, but I don't
know  where the right place.

My question is: what does the  source code need   to create a new
"category" of controls in the IDE?

For example, in the IDE has Standart, Additional, Common controls, 
Dialogs, etc..  I would like to add one,  called XXXX.

http://subefotos.com/ver/?cde4b0d1e683edcce7916b14775f8c28o.jpg

Thanks in advanced

----------------------------------------------------------------------
Blaazen · 2014-10-03 10:34

It is done via procedure RegisterComponent;.
Code: [Select]procedure Register;
...
procedure Register;
begin
  {$I ecslider.lrs}
  RegisterComponents('EC-C', [TECSlider]);
end;This will create new tab "EC-C" with component TECSlider - OR -
(if this tab already exists) will only add the component TECSlider
there.

----------------------------------------------------------------------
pusuni · 2014-10-03 11:10

Thanks a lot, Blaazen