[SOLVED] Create panel to put existing components on it. lazarus / 31-LCL ---------------------------------------------------------------------- Elmug · 2011-08-14 09:35 Hi good people, On form with existing components, I create Panel1. Then I change the parent of a component to be Panel1. Component is taken by Panel1, but component can not be seen. How to make the component visible? What is the right way to do it so the component is visible on the panel from the beginning? Thanks! ---------------------------------------------------------------------- Blaazen · 2011-08-14 09:55 QuoteComponent is taken by Panel1, but component can not be seen.Probably, component is out of visible area. You have to set correctly its Left and Top properties. These properties are relative to Parent. ---------------------------------------------------------------------- Elmug · 2011-08-14 10:23 Quote from: Blaazen on August 14, 2011, 11:55:43 amQuoteComponent is taken by Panel1, but component can not be seen.Probably, component is out of visible area. You have to set correctly its Left and Top properties. These properties are relative to Parent. Thanks Blaazen, True what you say, which I already had some earlier advice. But when I tried to apply the advice, some of the intuitive mouse grabbing did not seem to work. On top of that, there were  some fragments of components showing (consistently) that were not objects but pixels probably having to do with my graphics card/monitor. They were complete pieces, though, like the spin-edits of some boxes. The other thing is that I was trying to move various components at once, and that was not possible, because when one tries to lazo them, one is actually clicking on the form (selecting it). But I figured out that In the O.I. they can be grouped, and then, yes, they can be be moved in a group. It takes a little getting used to it. ---------------------------------------------------------------------- Bart · 2011-08-14 10:41 Quote from: Elmug on August 14, 2011, 12:23:31 pm... . On top of that, there were  some fragments of components showing (consistently) that were not objects but pixels probably having to do with my graphics card/monitor. They were complete pieces, though, like the spin-edits of some boxes. May I enquire what OS you are using? I've seen that a lot on my Win9x system and there is a bugreport in the bugtracker on that. No-one ATM has been able to reproduce this in XP or higher. If you can, it is relevant to the bugreport. Bart ---------------------------------------------------------------------- Elmug · 2011-08-14 11:58 Hi Bart, I am on Windows XP, with two monitors. But I will mention that on my system, similar occurances can happen on other softwares, but I have not minded that because to my recall no effect on operation. But on Lazarus the spin controls of one or two of the spinfloat boxes appeared broken off, but it was only show, no real split. I went ahead and ignored the looks and the application runs fine. I believe that this was consistent since all the times I tried this in the past, I saw the breakoffs. If any specific question, I'd see if can get some answers. I do have two laptops and can when I have a chance, see if that has to do with the hardware. I've found Lazarus rock-solid, though, and really like it. ---------------------------------------------------------------------- jamhitz · 2011-08-14 17:03 I have noticed that "at times" when I drop a control on a form and the move it to another place on the screen, the control remains "ghosted" its the original location ie it appears to be there (with resize handles and all) but it really does not exist there.  Normally, I just ignore it.  If and when I cannot ignore it  (eg I need to place another control there-abouts), I minimize and then restore the IDE window and Boom! The problem is solved. I know it is not a "real" solution but that should give you some solace... at least in the short-term. By the way, it is just me, or are you asking the same question twice just re-phased. OpenSuse 11.4/FPC 2.2.4/Lazarus 0.9.30/