[SOLVED] Cursor Placement in Editor lazarus / 21-General ---------------------------------------------------------------------- Slyde · 2022-04-13 14:28 When I click into the Lazarus Editor, the caret shows at the mouse point, instead of going to the beginning of a new line or the end of a line already there.  What can I change in the settings to stop the caret from locating itself in no-man's land, this virtual space? In another IDE, unchecking a box (enclosed in red) ensures the caret will situate at the beginning of a new line, or at the very end of a line with code.  NOT where the mouse click is done.  Is this possible with Lazarus? ---------------------------------------------------------------------- dseligo · 2022-04-13 15:22 Tools, Options, Editor, General: uncheck 'Allow caret to move past end of line'. ---------------------------------------------------------------------- Slyde · 2022-04-13 15:32 Ouch!  That's 110% embarrassing.  Can't believe I missed that, and I looked over it a dozen times Thanks, dseligo. ---------------------------------------------------------------------- Martin_fr · 2022-04-13 15:54 And, on the same page "caret skips tabs" to avoid the "tab zone"... And for scrolling the last real line so far up, that you can see a virtual empty page: "scroll past end of file". (Though there is no option to place the caret into that virtual space). In the "Keymap" (same dialog, but different page / look through the tree of pages), you can find various "word boundary move" commands. You can assign them to ctrl-left/right or any other key. ---------------------------------------------------------------------- Slyde · 2022-04-13 22:54 I'll check that out, too, Martin_fr.  Thanks for the insight.