Zeos 7.2 error
lazarus / 16-Databases

----------------------------------------------------------------------
Hansvb · 2015-01-02 22:06

Hi, when using ZEOS 7.2 Beta i get the following error message in
Oracle:
SET TRANSACTION ISOLATION LEVEL DEFAULT

i just "open"a select statement with a ZQuery

(The error mesage is get through ZSQLMonitor1)

----------------------------------------------------------------------
Leledumbo · 2015-01-03 05:28

Quote from: Hansvb on January 02, 2015, 11:06:20 pmHi, when using ZEOS
7.2 Beta i get the following error message in Oracle:
SET TRANSACTION ISOLATION LEVEL DEFAULT

i just "open"a select statement with a ZQuery

(The error mesage is get through ZSQLMonitor1)
It's not an error, it's a valid oracle statement issued by ZDbcOracle
to start the transaction support. If you have errors, it would be
something after that.

----------------------------------------------------------------------
Hansvb · 2015-01-03 12:18

than is the actual error not logged.
The program gives an acces violation error when a query is set to
active.

----------------------------------------------------------------------
Leledumbo · 2015-01-03 13:13

Quote from: Hansvb on January 03, 2015, 01:18:34 pmthan is the actual
error not logged.
The program gives an acces violation error when a query is set to
active.
Rebuild ZEOS with debugging info, and break when the exception occurs.

----------------------------------------------------------------------
Hansvb · 2015-01-09 20:29

It gets stranger.

Today i changed zeos 7.14 for 7.2 on my work pc. my program that uses
tzquery from ZEOS works fine at work.
Now i am at home, logged in on the my work network via citrix and the
same program (not compiled again) doesn't work. The query gives again
an access violation.


Just for tessting, I now changed back to zeos 7.14. and my programm
works good.

???

----------------------------------------------------------------------
EgonHugeist · 2015-01-09 21:55

Think about a minute:

Start from the premisse YOU are note the reporter.... What should this
post mean? Just "something" went wrong. I do not see anything to
support here or get the "strange" something fixed.

Add the debug-log and trigger the stmts, add a report, code snippets
to indicate what's going on. Better would be a test. Switch to Zeos-
Bugtracker, open a ticket and you'll get help.

Both posts are not helpfull, what's purpose of doing that, except
reporting a problem? Getting help can't be goal of the posts...

Michael, who wrotes 99% of 7.2 code.