LazReport -> FrDBDataSet lazarus / 13-General ---------------------------------------------------------------------- stratodream · 2008-02-19 01:19 Hallo, at design time on a datamodule i set a ZConnection and a ZQuery of Zeos Lib Components  and a Datasource, then i set from lazreport palette a FrReport ad FrDBDataSet components too. After setting all needed properties i begin to design report...when i put a DataMaster i can't see the FrDbDataset that i linked to FrReport... if i make double clik on the band it's the same....can'you tell me how i've to make to link at design time a FrDbDataset to MasterData band ? Regards, Antonio. ---------------------------------------------------------------------- tatamata · 2008-02-26 19:32 Hello. Check Tools-Toolbars-Object Inspector. It will open object inspector. When you place mouse on a band, object inspector wll be showing properties for it. One of properties is Dataset, where you need to write the name of a FrDbDataset for te band. Bare in mind that every data band must have its own FrDbDataset. Therefore, if you have a hierarchical report, every level of hierarchy must have its own dataset. This is different than, for example, MS Access, where you need only one dataset for a report.... Regards, Zlatko ---------------------------------------------------------------------- stratodream · 2008-02-27 13:16 i tryed in this way but i don't see the frdbdataset that i would associate... I use firebird with zeos library on windows xp... ---------------------------------------------------------------------- tatamata · 2008-02-27 15:08 You need to drag&drop; it on the form first. I think it will not be listed in frReport, but you can manually enter its name in the property. ---------------------------------------------------------------------- stratodream · 2008-02-27 20:50 i usually use fastreport on delphi 7...it's in lazarus that lazreport don't play fine... ---------------------------------------------------------------------- tatamata · 2008-02-28 11:05 Well, be patient to get used on LazReport. Read the documentation. I used it a lot and is working fine. It is clumsy to align controls on it, but, generally speaking it works OK. You can see it working in my application titled "Planingz" (http://matalab.freehostia.com/planingz_trial_1_0_0_setup.exe). Regards, Zlatko