Locking (not anchoring) component position at Design time lazarus / 10-Designer ---------------------------------------------------------------------- Ten_Mile_Hike · 2025-11-28 17:48 IIRC when I used Delphi and Visual Basic well over a decade ago "I think that" there was a way to prevent the accidental movement of components on your form while in design mode.  I AM NOT TALKING ABOUT "ANCHORING" LIKE ANCHORING TO LEFT etc. I am talking about the ability to keep a component from changing position during DESIGN even if you try to drag them. To move them you had to UNLOCK their positions first. Does Lazarus have this ability, because I have searched and can't find it - so it might not exist. AND perhaps I am imagining this functionality completely!!! ---------------------------------------------------------------------- dseligo · 2025-11-30 00:15 Quote from: Ten_Mile_Hike on November 28, 2025, 06:48:01 pmI am talking about the ability to keep a component from changing position during DESIGN even if you try to drag them. To move them you had to UNLOCK their positions first. Does Lazarus have this ability, because I have searched and can't find it - so it might not exist. AND perhaps I am imagining this functionality completely!!! AFAIK, no ---------------------------------------------------------------------- Martin_fr · 2025-11-30 00:19 I am also pretty sure, that is a solid NO. (Not to the idea, but to: is it currently implemented)