Jose: "Jose Carlos Lord Apple" wrote in message news:f57a920b.0402110722.615ff30f@posting.google.com... > Hi, > > I got an 5Mb Corvus Constellation HD and it is so difficult to do in > Brazil. But, I have a few questions: > > 1. It has 4 dip switch on back. All that are seted to CLOSE position. > What that switches does ? Unique device ID. Set to any non-zero number. > 2. It has 4 red switches on front (+- hidden). All that are seted to > left side. What that switches does ? From left to right: 1. Normal | format 2. Single | Multiplexer 3. Normal | format 4. Normal | reset Flip all switches to the left. When formatting flip the third switch to the right. > 3. It has 2 connector on back: PROCESSOR and DRIVE. Witch of then I > must plug the flat cable from card ? I'm usind PROCESSOR. PROCESSOR is correct. Use DRIVE to daisy chain another Corvus. > 4. I turn on the HD and 3 lights on FRONT starts ON: FAULT, BUSY and > READ. After some busy time, the FAULT and BUSY turn off. But, If I > turn on the IIe, the HD doesn't start to boot (the Corvus Card is in > Slot 7). Put the Corvus card in Slot 6 and your floppy card in Slot 4. Other slots may work but this is what the manual recommends. I have the Corvus Diagnostics Soft (thanks Jean) and the > program find the HD (the busy light flashs) and the show me: > - ROM 58 > - Firmware: > V18.4AP -- Const II - 11/82 > > How can I format it ? In the Diag Software has a format option, but > when I select it, the soft say me to set the format key on HD. What > key is it ? Flip the Format key (the third from the left on the front panel) to the right. How can I do to ProDOS recognize it ? The Corvus disk system is a DOS 3.3 based. It gives you multiple DOS volumes from which to run programs.I have heard that there is a ProDOS driver but have never seen it. > Sorry by those all questions, but I don't know anyone that has a > Corvus HD in Brazil, so, help-me please !!!!!!!!! > > Thanks a lot !!!! > > Sorry by my TERRIBLE English !!! > > Jose Carlos > Brazil