Posts by drahflow@infosec.exchange
 (DIR) Post #B4PwnTnXbzZyVKOHEu by drahflow@infosec.exchange
       0 likes, 0 repeats
       
       @isibell > (otherwise it would be silly to drink it at 9:30pm)This, too, shall pass. *sips some Assam*
       
 (DIR) Post #B4jDUegcIMTtzo03g8 by drahflow@infosec.exchange
       0 likes, 0 repeats
       
       @azonenberg This works also (with more precision but less weld depth) with a soldering iron set sufficiently low.
       
 (DIR) Post #B4jE7GnT38QzCJcKjA by drahflow@infosec.exchange
       0 likes, 0 repeats
       
       @azonenberg At least LDPE, PLA and ABS seem to leave my tip nicer than before. Then again, I don't solder much and it might well be my inability talking. ^^
       
 (DIR) Post #B5Nbjv9tVHyoeMu4mm by drahflow@infosec.exchange
       0 likes, 0 repeats
       
       @azonenberg Is this an alternative proposal to the recent IPv8 thing?
       
 (DIR) Post #B6pG2E05xJ3Qtjmpuq by drahflow@infosec.exchange
       1 likes, 0 repeats
       
       @nova May I please use your beautiful face for future reaction picture purposes?