Newsgroups: comp.sys.novell
Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!bronze!mckimg@bronze.ucs.indiana.edu
From: mckimg@bronze.ucs.indiana.edu
Subject: Netware 3.11 and Zenith
Message-ID: <1991Jun4.141932.27696@bronze.ucs.indiana.edu>
Sender: <mckimg@bronze.ucs.indiana.edu>
Organization: Indiana University
Date: Tue, 04 Jun 91 09:19:18 EST
Lines: 31

Hello everyone, me again.

I have set up many 3.11 servers, and have never had this problem before:

	Zenith 386 (not sure which model -- each Zenith seems to be different)
	 	as a server.
	Zenith ESDI Disk Controller (DTC)
	
I am able to run 3.11 pretty much successfully except -- random characters
appear constantly on the console.  The characters don't start until I load
the ISADISK driver that came with Netware.

I have:
	1. Used two completely independent sets of disks, to check for
	   software corruption.
	2. Swapped in an identical DTC controller.

Other than the character garbage, everything works beautifully -- I can log 
on, transfer files, etc.

Does anyone have any ideas for a fix?  Is there a special "Zenith ESDI" 
driver?

Thanks in advance for any help you can give me!!

=========================================================================
Geoffrey W. McKim			Internet: mckimg@ucs.indiana.edu
UCS Networks/LAN Group			BITNET: mckimg@iuamber
Indiana University Bloomington
855-4643
=========================================================================
