Newsgroups: comp.protocols.tcp-ip.ibmpc
Path: utzoo!utgpu!cunews!micor!latour!mcr
From: mcr@Sandelman.OCUnix.on.ca (Michael Richardson)
Subject: Re: NCSA - Telnet and FTP - BOOTP/rarp
Message-ID: <1991May8.220407.17633@Sandelman.OCUnix.on.ca>
Organization: Sandelman Software Works, Debugging Department, Ottawa, ON
References: <200882.28215371@uctvax.uct.ac.za>
Date: Wed, 8 May 1991 22:04:07 GMT

In article <200882.28215371@uctvax.uct.ac.za> hartr@uctvax.uct.ac.za (Dave Roberts) writes:
>3) I have myip=BOOTP with a IPX and IPXPKT.  FTP will not work, error is
>   "Error initializing network".  When I use FTP with myip=MYIPNUMBER
>   it works.  Is there something I am missing to make FTP work with
>   myip=BOOTP?

  I experienced a similar thing with Telnet 2.2D.
  When using a packet driver (3c501.com at int 0x60) I couldn't an IP
address via RAPR. (I don't recall if I got the same error though -- I
believe that it may have just timed out)
  When switching to the internal 3c501 driver, I had no problem at
all (with both Telnet and ftp). Could this be a limitation of the
packet driver??


-- 
   :!mcr!:            |  The postmaster never | So much mail, 
   Michael Richardson |    resolves twice.    |  so little time.
HOME: mcr@sandelman.ocunix.on.ca 	Bell: (613) 237-5629
    Small Ottawa nodes contact me about joining ocunix.on.ca!
