Newsgroups: comp.lang.pascal
Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!maverick.ksu.ksu.edu!ux1.cso.uiuc.edu!s.psych.uiuc.edu!amead
From: amead@s.psych.uiuc.edu (alan mead)
Subject: Re: Extracting from a unit (or CRT vs. ANSI)
Message-ID: <1991Apr5.212056.26150@ux1.cso.uiuc.edu>
Sender: usenet@ux1.cso.uiuc.edu (News)
Organization: University of Illinois at Urbana
References: <26447@adm.brl.mil>
Date: Fri, 5 Apr 1991 21:20:56 GMT
Lines: 21

209507097@ucis.vill.edu (MCREE, JAMES F) writes:


>	I need to use the "KeyPressed" and "ReadKey" functions in CRT in Turbo 
>5.0, but can't use the CRT unit because it will cause the program to ignore the 
>meaning of my ANSI codes.  There are three general ways that I can think of for 
>...

I have an ANSI.SYS driven CRT replacement unit that I got from (I
think) SIMTEL that sounds like what you want--just what ANSI codes does
CRT cause your code to ignore?!

I believe the unit is called ANCRT and I can upload it if it is no
longer available (or if I'm wrong and I didn't get it from SIMTEL).

If you don't want to use the whole unit, the source is included, so you
can see what ReadKey does.  In fact, there is a better function GetKey
(or something) that may vbe helpfull (like perhaps it is ReadKey and
not the CRT unit that is ignoring ANSI codes).

-alan mead : amead@s.psych.uiuc.edu
