Welcome to MIDI Station Sequencer

Introduction

   MIDI Station Sequencer uses the RTMIDI subsystem for its playback and recording of
   sequences.  Therefore you MUST have a RTMIDI compatable soundcard/driver in order
   to use this program.  If you do not please read the accompanying MSTATSEQ.HLP file under
   System Requirements - Setting up your soundcard for information on how to get your system
   RTMIDI compatable.

   This program also uses the new high-resolution timer so there are a few things that you
   should be aware of:

    1) When using this program you should not use any Windows and/or DOS programs
    2) The minimum configuration that will give back acceptable performance is a
       486 DX/4 100 MHz.  Any system will work but your results may not be acceptable.

Installing the program:

   1) Unzip this file into a directory
          (Obviously you've already done that since you're reading this!)
   2) Type install
   3) You will be prompted to enter a path where the program will reside
   4) The installation routine will create a folder and program objects for you.


Troubleshooting and Technical Issues

   If you need help getting your system to be RTMIDI compatable, please READ the included
   MSTATSEQ.INF file.  It contains many suggestions and ways of getting your system ready.
   If after doing this nothing works - send me some email at: cdhodge@ibm.net. I've probably
   encountered the same problem and can help you with it.  Also take a look at my website -
   it has the most current configuration/setup problems and directions.


Enjoy!!!


Christopher Hodges
Author of MIDI Station and MIDI Station Sequencer
cdhodge@ibm.net
WebSite: http://www.geocities.com/SiliconValley/Horizon/6780
