\documentclass[tikz,border=6mm]{standalone} \usepackage{tikzphysics} \begin{document} \begin{tikzpicture} \node[font=\bfseries] at (2,1) {Two-point paths}; \node[font=\bfseries] at (7.5,1) {Positioned spring nodes}; \draw[spring] (0,0)--node[above=3mm] {$k$} (4,0); \node[spring,minimum width=4cm,label=above:{$k$}] (H) at (7.5,0) {}; \fill (H.start) circle(1pt) (H.end) circle(1pt); \draw[spring] (2,-4.5)--(2,-1.5); \node[spring,rotate=90] (V) at (7.5,-3) {}; \fill (V.start) circle(1pt) (V.end) circle(1pt); \draw[spring,amplitude=2mm,segment length=5mm,pre length=4mm, post length=4mm] (0,-7)--++(30:4); \node[spring,anchor=start,minimum width=4cm,rotate=30, amplitude=2mm,segment length=5mm,pre length=4mm,post length=4mm] (I) at (5.5,-7) {}; \fill (I.start) circle(1pt) (I.end) circle(1pt); \node[align=center,font=\small] at (4.75,-8) {Same coil settings and decoration in both forms.\\Dots mark exact node attachments.}; \end{tikzpicture} \begin{tikzpicture} \node[spring,minimum width=4cm,pre length=5mm,post length=7mm, amplitude=2mm,segment length=4mm,show anchors,show keys, physics debug/anchor list={start,end,center,coil-start,coil-end,north,south}, physics debug/anchor families={axis}, physics debug/anchor samples={0,25,50,75,100}] (S) {}; \end{tikzpicture} \begin{tikzpicture} \node[ground,ground width=6cm,anchor=surface] (G) at (2.5,-.4) {}; \node[wall-left,wall height=1.4cm,anchor=surface-50] (W) at (0,0) {}; \node[spring,anchor=start,minimum width=4cm,label=above:{$k$}] (S) at (W.surface-50) {}; \node[block,anchor=west,minimum width=1cm,minimum height=.8cm] (B) at (S.end) {$m$}; \node[align=center,font=\small] at (2.5,-1.35) {Named spring attached to the wall and block.\\The block is placed directly at the spring's end.}; \node[spring,spring length=2cm,pre length=0pt,post length=0pt, label=above:{Shorter node}] at (.5,-2.8) {}; \node[spring,spring length=3.5cm,label=above:{Longer node}] at (4,-2.8) {}; \end{tikzpicture} \begin{tikzpicture} \node[spring,rotate=30,minimum width=4cm,show anchors,show keys, physics debug/anchor list={start,end,center,coil-start,coil-end}, physics debug/anchor families={axis}, physics debug/anchor samples={0,50,100}] {}; \end{tikzpicture} \end{document} .