Posts by joe@akk.joelanders.net
 (DIR) Post #AhrxTb3RDJgO8E70t6 by joe@akk.joelanders.net
       2022-11-25T00:45:19.900035Z
       
       0 likes, 0 repeats
       
       Penglord, P.Vanillaboy, DJ Mell G, viko63 - BOOTLEG TAPE.MP4https://www.youtube.com/watch?v=M_utlcqPw_k
       
 (DIR) Post #Ahtf83BEYK4M8HFqjo by joe@akk.joelanders.net
       2024-03-05T20:17:06.565318Z
       
       0 likes, 0 repeats
       
       @pandora @fesix Looks like AM while ramping up and down, but I can’t figure out what’s going on in the middle of picture 3. The bit and part together have the same resonant frequency as the bit alone?.?.?.
       
 (DIR) Post #Ahtf85xWDlsgkbrRHE by joe@akk.joelanders.net
       2024-03-05T21:03:21.672761Z
       
       0 likes, 0 repeats
       
       @pandora @fesix I see, I see. Why do the motors ramp up and down at constant rate at the beginning and end, but do some kind of curvy thing in the middle of #3? I was guessing the curve was because of friction. (I’ve never played with a CNC thing before so I don’t know what I’m talking about)
       
 (DIR) Post #Ahy4CQypHY0aaiTh44 by joe@akk.joelanders.net
       2022-11-25T00:43:59.723412Z
       
       0 likes, 0 repeats
       
       Detroit's Filthiest - Gardens Of Babylon https://www.youtube.com/watch?v=-wPW5tEqZBA