Subj : Question about compiling To : Nigel Reed From : Joacim Melin Date : Thu Jul 02 2026 10:38 pm NR> On Thu, 2 Jul 2026 21:31:08 +0000 NR> "Joacim Melin" (2:221/242) wrote: >> WvV> Hi Joacim, >> >> WvV> On 2026-07-02 19:59:53, you wrote to All: >> >> JM>> I had to compile Binkd on Rocky Linux 10 and everything seems >> JM>> to work fine. Outgoing packets are sent properly but Binkd does >> JM>> not respond to incoming traffic from the Internet. I have >> JM>> verified that the firewall rules in OPNsense (which powers my >> JM>> Firewall) is not the issue and Binkd responds fine if I telnet >> JM>> to port 24554 on my internal network. >> >> WvV> Did you try both 127.0.0.1 (localhost), and the local ip number >> WvV> on your network (like: 192.168.0.x), and their IPv6 >> WvV> counterparts? >> >> WvV> If both work, it must be a firewall or router problem... >> >> >> WvV> Bye, Wilfred. >> >> Yes both localhost and the local IP address works. There are no >> local firewall active on the server and other services (nntp, etc) >> works fine from the Internet. The port (24559, forwarded to 24554 in >> the OPNSense firewall) works fine with my other Binkd installation >> for this node number when I tried to direct the traffic to that >> server as a test. Binkd on the new server will simply not work with >> any traffic from the Internet. >> >> I enabled this in the binkd configuration: >> >> iport binkp >> oport binkp >> oblksize 4096 >> timeout 5m >> connect-timeout 5m >> bindaddr 10.0.2.237 >> listen * >> >> >> It did not help. >> >> I agree this looks like a firewall configuration issue but I have >> tested everything and the only conclusion I can find is that Binkd is >> the issue. I'll just walk over to the corner of shame here - it was my firewall (OPNsense) that was the problem. Starting with OPNSense 26.1 the old Port Forward stuff was removed and now you configure a Destination NAT and then you have to make sure you set the firewall rule setting in that Destination NAT setting to "Pass". It doesn't seem to help to create the rule on the WAN interface manually, you have to do it when you create the Destination NAT setting for that port. Thanks all for patience and answers. --- NiKom v2.6.0 * Origin: Delta City (deltacity.se, Vallentuna, Sweden) (2:221/242.0) .